Gold Kitchen Faucets

Gold kitchen faucets are the accent that decides how warm a kitchen reads, in a room that is otherwise mostly stone and cabinetry. This OroDwell page collects the faucets finished in brushed and polished gold, with notes on deck holes, spout reach and how the finish behaves at a sink used all day.

How to choose gold kitchen faucets

Start with the tone, because gold is not one color. Brushed and satin gold sit matte and slightly cooler, champagne leans pale and pink, and polished brass is bright and almost mirrored. The same fixture reads yellow against white marble and nearly bronze against walnut, so judge it beside the counter and a cabinet door rather than on its own.

Then work through the sink. A single hole fitting needs one opening of about 1 3/8 inches, a widespread deck mount set needs three on 8 inch centers, and a wall mounted spout needs supply lines roughed into the wall behind it. Counting the holes already cut in your counter or sink deck narrows the list faster than any other filter.

Reach and height come last. A spout that clears the back of a deep basin lets you rinse a sheet pan; one that stands too tall blocks a window sash from opening. Measure from the deck to the sill or cabinet above, then check that figure against the height listed on the product page.

Deck holes and spout reach for gold kitchen faucets

The numbers below are the standard American sink dimensions these fittings are built around.

• Single hole: one opening near 1 3/8 inches, the usual cutout on a modern undermount sink.
• Widespread set: three holes on 8 inch centers, spout in the middle, handles either side.
• Deck plate: covers a three hole cutout when the replacement needs only one.
• Spout reach: 8 to 10 inches out on a standard 22 inch bowl puts the stream near the center.

Height matters as much as reach. A tall gooseneck fills a stockpot but splashes in a shallow bar sink, and a pull down head needs roughly 8 inches above the spout to lift out of its dock.

Questions about a gold faucet finish

Does brushed gold show water spots?

Less than a polished surface does. The fine grain on a brushed or satin finish breaks up mineral marks, so hard water leaves a lighter trace and a dry cloth clears it. A mirrored finish behaves like glass and shows every droplet, which is worth knowing at a sink used many times a day.

Can I mix this finish with hardware I already have?

Yes, within reason. Two metals in one kitchen read as a decision and four read as an accident. Warm metal at the sink pairs comfortably with matte black cabinet pulls or with unlacquered brass elsewhere. The parts that most often break the match are the sink strainer and the soap dispenser.

How do I keep the finish even?

Wipe with a soft cloth wrung out in warm water, then dry it. Abrasive pads, bleach and lime scale removers dull a plated surface and can cut through it at the edges first. Read the care note on each product page, since a living finish is meant to change with use and a coated one is not.

Other pages in this family: Bathroom Faucets, Kitchen Faucets, Single Hole Bathroom Faucets and Black Kitchen Faucets. The full category is Faucets.